-
Mop/Wet Vacuum Stripping System: Dilute in cold or mildly warm water from one part product to 2 parts water for heavily built‐up or highly burnished finishes, to one part product to five parts water for normal build up. Apply liberally with a mop to an area small enough so as not to allow the product to dry and allow standing for 3 to 5 minutes. Agitate with a mop and remove solution and old finish with a wet vacuum. Allow floor to dry thoroughly and apply new finish as directed by manufacturer. If complete stripping is not accomplished repeat above procedure before re‐application of new finish. Floor Machine Stripping System: Dilute and apply product as above using a dilution of 1 part product to 16 parts water varying according to build‐up conditions. Product may be applied with a mop or Automatic Scrubber. Allow to stand for 3 to 5 minutes, scrub with a rotary floor machine or automatic scrubber equipped with stripping pads. Remove solution and old finish with a wet vacuum and allow floor to dry completely. If desired, a rinsing step can be added. Apply new finish per manufactures recommendation. -
Designed to remove layers of floor finish in less time, with less effort, and no rinsing. In many applications, the entire stripping process can be completed without the use of a floor machine and pad. Labor saving, reduces labor hours by 30-50%- 55% active stripper. The fastest working finish liquefier and active speed stripper that easily cuts through multi-layers of burnished floor finish.
- Low foaming makes pickup eas
-
Mix two ounces “Pro-Zyme” per gallon of hot water. Spray onto soiled areas of carpet. “Pro-Zyme” is fast acting and requires only a short time to break down grease and soil. Extract in the normal manner.
For Hydro-Force application, add 16 ounces (8 scoops) “Pro-Zyme” to the 5-quart Hydro-Force reservoir and fill with hot water. Apply using the 9 to 1 ratio.
-
Apply to contamination. Agitate gently to dissolve contamination and blot up contamination with a dry, absorbent cloth. This product can damage some surfaces and materials so always test on an inconspicuous area before using. -
Truck Mounted Systems:
Use 1 ½ lbs. (3 cups) of powder per 5 gallons of water for concentrate solution. Set Chemical injection at 2 GPH for stain resistant carpet 3-4 GPH for commercial and non stain resist.
Portable Extractors:
Use 2 ounces per 10 gallons hot water for stain resistant cleaning and 3 ounces per 10 gallons hot water for non stain resistant.
-
Truck Mounted Systems:
Use 1 ½ lbs. (3 cups) of powder per 5 gallons of water for concentrate solution. Set Chemical injection at 2 GPH for stain resistant carpet 3-4 GPH for commercial and non stain resist.
Portable Extractors:
Use 2 ounces per 10 gallons hot water for stain resistant cleaning and 3 ounces per 10 gallons hot water for non stain resistant.
-
For ready to use solution on normal soil use 2 oz. per gallon of water. For heavy soils adjust the dilution to match the soil load. -
As a Pre-spray: Use 2 oz. Firestorm per gallon of water and dissolve completely. For injection sprayers such as Hydro-Force, dissolve 18 oz. of Firestorm into 1 gallon of water for concentrate solution. -
This is a ready to use multi-phase product. Shake the bottle very well to evenly distribute al phases before using.
Use a trigger sprayer to mist the product evenly and conservatively onto the grayed areas and blend into the fibers with a carpet groomer. Begin with a light application and increase the application as needed. The product can be removed by bonnet or hot water extraction while it is wet. However once it dries it becomes more permanent.
